Multiphase Flow in Oil and Gas Production Wells and Pipelines

Download or read book Multiphase Flow in Oil and Gas Production Wells and Pipelines written by Andrew Joseph and published by . This book was released on 2015-05-14 with total page 150 pages. Available in PDF, EPUB and Kindle. Book excerpt: This extensively research book assembles a tremendous amount of practical information on Multi-phase flow in oil and gas production wells and pipelines. The book summarizes those fundamental concepts with relevance to a broad spectrum of multiphase flows. This book is organized as follows.Chapter 2 gives an overview of multiphase flows looking at the flow regimes that are generally used, trends in multiphase flow modelling. Chapter 3 gives a detailed overview of the physical model of wellbore flow used. The concept of drift flux is briefly discussed. Methods used to the solve model equations numerically are discussed in Chapter 4. It is shown that the traditional central schemes are unable to capture properly the physics of the flow. For the complex flow systems, which include several non-linear coupled differential equations, a new computation algorithm is proposed. First, a Jacobian splitting must be applied accounting for different directions of the propagation of information. In Chapter 5 an assessment is performed of the impact of the chosen time-integration scheme on results of data assimilation based on the extended Kalman filter approach and also discusses the use of the implicit Euler scheme. Chapter 6 starts from analysis of the transient pressure signal generated in the wellbore due to inflow from the reservoir. The possibilities of indirect multiphase flow metering are then discussed. Finally, the method, which was limited to a rapid inflow scenario, is extended in Chapter 7 to a gas coning control application, in which the relevant quantities are estimated from multiple pressure measurements and single multiphase flow measurement at the outflow. The performance of both techniques proposed is evaluated using a series of simulation based test cases and measurements generated by the OLGA simulator. This book is targeted at final year students, graduate students and researchers at the cutting edge of investigations into the fundamental nature of multiphase flows; it is intended as a reference book for the basic methods used in the treatment of multiphase flows.