Chloride Ingress Into Submerged Concrete Under Sustained Load

Download or read book Chloride Ingress Into Submerged Concrete Under Sustained Load written by Andrew Karam and published by . This book was released on 2014 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: A harsh, cold, and icy environment is of no surprise to the conditions of a winter climate, where the wide use of de-icing salts on roads and highways allows for the initiation of chloride-induced corrosion of the reinforcement of concrete structures; a reduced service life, loss of structural integrity, visible damages, and ultimately structural failure are among the many unwanted effects of rebar corrosion. Chloride ingress into concrete has been extensively studied for the last four decades; however, most of the relevant research to date does not take into account the effects of sustained loading on chloride transport properties. Therefore, the objectives of this study were to investigate the influence of sustained compressive and tensile stresses on chloride ingress into concrete, and ultimately to understand what the effect of sustained stress is on chloride penetration depth, on chloride concentration by % weight of concrete, and on apparent diffusion coefficients by comparing results to those of unloaded control specimens. To achieve these objectives, six post-tensioned and four non-reinforced control concrete beams were constructed with different water-to-cement (w/c) ratios and completely submerged in a 4-5% de-icing salt (NaCl) solution for 12 weeks, allowing chloride transfer to be completely governed by continuous diffusion. The effects of supplementary cementing material on chloride ingress are also studied. Concrete beams were post-tensioned to induce variable sustained compressive and tensile stresses along the beam. After 12 weeks of exposure, beams were fractured at specific locations and sprayed with a 0.1N silver nitrate (AgNO3) solution to determine average penetration depths; chloride concentration profiles were obtained from potentiometric titration of grinded powder samples. Apparent chloride diffusion coefficients were then obtained from the results of spraying AgNO3 and titration, the latter by non-linear regression curve-fitting to Fick's second law of diffusion. A good agreement between results from both methods reveals that the use of AgNO3 in field is acceptable in predicting the rate of chloride ingress in concrete sustaining stress. The chloride diffusivity for each profile, relative to that of the unstressed section, was related to the compressive and tensile stresses in the concrete section. The experimental results indicate the dependence of chloride ingress and concentration on the type and level of sustained stress. An analysis of the results to study the effects of the w/c ratio using colourimetric (silver nitrate spray) and potentiometric titration methods was also completed.